ElecGear Hall Joystick Kit Replacement for Xbox One & Series S|X Controller, 2x Hall Effect Control Stick + 2x Calibration PCB + Desoldering Repair Tools for Analog Stick Thumbsticks – HL-XB

Mannequin: HL-XB Corridor Joysticks Substitute for Xbox One, One S|X, Elite 1 and Sequence S|X Calibration PCB with MCU for the best Centering and Rocking Curve A Copper Heating Plate and Solder Wick assist quite a bit for the Desoldering Reminders: 1.This mannequin works with Xbox One, One S|X, Elite 1 and Sequence S|X controllers fashions: 1537, 1697, 1698 Elite, 1708, 1914 2.🔺No batteries required throughout calibration 3.The operation takes critical soldering ability and gadgets. The soldering iron have to be greater than 60W 4.Significantly comply with the steps we introduced on the information for this package is novel and difficult 5.Teardown screwdriver instruments, USB wired/wi-fi controllers, Different soldering instruments and supplies are required, nevertheless NOT included What’s within the field: 2x Corridor Joysticks 2x Calibration PCB 1x Heating Plate 1x Solder Wick 1x Gap Cleansing Tubes
[2x Hall Joysticks Replacement for Xbox] – Corridor thumbsticks work with Xbox One, One S|X, Elite 1 and Sequence S|X controller. With the electromagnetic corridor Impact sensors inside, the management stick delivers increased sensitivity and accuracy. No extra put on of conventional carbon movie resistor, say goodbye to drifting. Constructed from sturdy materials with glorious rocking construction, it offers smoother motion and longer lifespan
[2x Added-on Calibration PCB] – The tiny PCB was designed to stack on the again of fundamental board. The shifting sign is enter to the excessive pace MCU. The calibrated sign outputs to the primary board of controller. Join the controller to a PC with a USB cable. You’ll be able to fantastic reset the middle and trim the curve through an internet hyperlink. The correct centering with no drift is important for FPS aiming
[Desoldering Tools included] – A copper heating plate melts all of the solder joints concurrently merely with a soldering iron. Solder Wick, Holes Cleaner and easy PCB holder included. With as many as 14 prongs, eradicating the outdated drawback stick is probably the most tough process. It’d shouldn’t be appropriate for newbies, although we added these serving to hand within the package
[Compatibility and Reminder] – 1. Please rigorously research the photographs for suitable controller. 2. The soldering iron have to be greater than 60W. And the operation takes critical soldering ability and gadgets to desolder the outdated stick off the PCB. 3. Significantly comply with the steps we introduced on the set up information for this package is novel and difficult
[What’s in box Model: HL-XB] – 2x Corridor Joysticks, 2x Calibration PCB, 1x Heating Plate, 1x Solder Wick, 1x Gap Cleansing Tubes. (🔺Teardown screwdriver instruments, USB wired/wi-fi controllers, Different soldering instruments and supplies are required, nevertheless NOT included.)